题库分类
题库分类
>
4G和通信理论
题目内容
现网中的RRC建立失败情况,涉及方面较多,总结目前遇到的几种情况导致的RRC建立失败,主要包含:()、()、()[回答3种](多选题)
A:(覆盖问题)
B:(频率扰码问题)
C:(传输问题)
D:(小区码资源拥塞)
题目答案
查看答案
扫码查看本题答案
相关问题列表
👉
光缆段错误包含以下哪些()
[1]
对于新增资源数据,在设备入网验收时,各专业网络和系统接维人员应对______的完整性和准确性进行100%核查。
[2]
资源管理的资源范围,包括中国移动通信集团公司所辖的(),以及前述实体网络资源相关的可分配逻辑资源。
[3]
对于50ms的延迟限(对于VoIP而言是典型的),LTE上行8ms的HARQ RTT意味着每个包可能高达()次传输
[4]
传输综合网管系统支持哪()电路调度方式?
[5]
对于光缆命名规则,描述正确的是
[6]
ICIC技术就是在相邻小区之间进行协调,以避免或降低ICI这种“协调”实际上是通过在小区边缘采用小区频率复用方法实现的,可分为:
[7]
无线端口状态为以下哪个状态时必须要有电路名称
[8]
(LTE)3GPP R8 及以后的SGSN与MME之间的接口是()
[9]
综合业务接入区划分原则()
[10]
《中国移动网络资源管理试行办法(2017年)》中明确要求各省公司各类流程的应用率达到(),规范率达到()以上
[11]
在同频邻区质量高于服务小区质量时上报,源eNodeB启动同频切换请求的事件是:
[12]
下列哪一选项是用户可以自定义的? ①告警规则 ②告警指示颜色 ③KPI门限 ④网络拓扑结构
[13]
CC16 单板放置在1槽位,则固定IP是____
[14]
AAA协议中的3个A分别代表
[15]
E-RAB的建立,均可由()和( EPC)发起
[16]
AAUA9611有()通道
[17]
STM-N的帧包括三个基本部分组成,它们是()
[18]
非压缩情况,LTE 1个20M单天线占___个AxC
[19]
现场进行以下哪种操作后,需要在综合资源系统中进行传输电路调整()
[20]
网络拓扑组成包含?
相关考题
👉Whatstatementaboutcellsplitasameansofincreasingcapacityistrue?
A:A 1:4 split increases the capacity per square kilometer by a factor of eight.
B:In a 1:4 split, the antenna directions on all sites that existed before must be changed 30 degrees.
C:In a 1:3 split, the antenna directions on all sites that existed before must be changed 30 degrees.
D:A 1:3 split increases the capacity per square kilometer by a factor of six.
E:All the statements above are incorrect.
查看答案
👉WhatistheaverageTCHreuseina12/8/7/4MRP?
A:6.3
B:7.5
C:7.75
D:8
E:9
查看答案
👉Whatismeantbya“fractionallyloaded”network?
A:A network where DTX is used on both uplink and downlink.
B:A network where the data transmission is very bursty.
C:A network where the number of TRXs per cell is smaller than the number of hopping frequencies.
D:A network where the channel utilization never goes above Aserved/#TCHs.
E:A network where the “hardware load” is higher than the “frequency load”.
查看答案
👉Whyareneighboringcellrelationscreatedbeforeusingthefrequencyplanningtool?
A:To set hysteresis parameters.
B:For export to CN
C:To estimate adjacent -channel interferenc
D:For application of carrier separation constraints.
E:To estimate co-channel interferenc
查看答案
👉WhatdotheLEVEL,LEVTHR,LEVHYST,PSSTEMP,andPTIMTEMPparametershaveincommon?
A:They are used in the radio network feature, DTX.
B:They are used in the radio network feature, dynamic power control.
C:They are used in an overlaid, underlaid cell structur
D:They are used in an hierarchical cell structur
E:They are used in the radio network feature, cell loading sharing.
查看答案
5G题库刷题